HANNOVER MESSE 2018,
23. - 27. April
Halle 5, Stand B29
We offer round bars, tubes, rectangles, squares, hexagon in Bronze CuSn7Zn4Pb7, Bronze CuSn12, Bronze CuSn10Zn, Bronze CuSn10, Bronze CuSn12Ni and Bronze CuSn12Pb.
Wir produzieren Rundstangen, Vierkant, Sechskant, Flach.
Wir bieten Kupfer in folgenden Ausführungen: E-Cu57, Cu-ETP), SE-Cu (Cu-PHC / Cu-HCP), SF-Cu (Cu-DHP), CuCrZr (CuCr1Zr), CuNi2Si und CuCo2Be.weiterlesen
Wir produzieren CuSn7Pb15-C (CuPb15Sn), CuSn5Pb20 (CuPb20Sn)
CuSn10Pb10-C (CuPb10Sn), sowie Rundstangen, Büchsen (Flach auf Anfrage).weiterlesen
Wir produzieren CuAl10Fe5Ni5, CuAl10Ni5Fe4, CuAl11Fe6Ni6, CuAl10Fe2-C
Rundstangen, Büchsen, Flach, und Sechskant Stangen.weiterlesen
We offer round bars, tubes, rectangles, squares, hexagon in Bronze CuSn7Zn4Pb7, Bronze CuSn12, Bronze CuSn10Zn, Bronze CuSn10, Bronze CuSn12Ni and Bronze CuSn12Pb.weiterlesen
Unibar 400-15 has a ferritic structure, obtained via heat treatment (130-190 HB), and is therefore used when machinability and a good surface finish are the required characteristics.
Because of its ferritic structure it is recommended for uses requiring high heat and/or electric conductivity, as well ...weiterlesen
This is the hardest grade with the highest resistance (220-280 HB, depending on dimension).
Its most important quality is the fact that the structure is also pearlitic on the outside rim (90% pearlite), and is therefore suitable for those applications in which high resistance to wear is required in ...weiterlesen
This is one of the hardest grades, (190-260 HB,) and is therefore used when high tensile strength and/or resistance to wear is required, because of its pearlitic structure.
Its surface finish is better than that of other softer qualities because of its better structural cohesion, which allows surface ...weiterlesen
Unibar 250 offers a good combination of strength and wear resistance with average hardness (160-230 HB), while still possessing reasonable machinability and excellent surface finishes.
Noise and vibration damping are good in this grade.weiterlesen
This is the softest of the Unibar grades, (120-200 HB) and is therefore recommended if your requirements are for good machinability with low requirements of tensile strength and resistance to wear.
In addition, because of its ferritic structure, it is recommended for applications requiring good thermal ...weiterlesen
United Cast Bar Ltd produce a range of continuously cast irons Unibar in Grey Flake, GG20, to GG35, Nodular Iron GGG40, to GGG70 along with special grades, and specifications to meet customer requirements, Unibar is suitable for those applications whose geometry is close to our standard round, square ...weiterlesen
Auf der Merkliste