HANNOVER MESSE 2020,
20. - 24. April
Diverter valves is used to divert flow towards different outlets.
These valves are used to open or close oil flow in a circuit even with maximun pressure.
Sequence valve is used to feed 2 cylinders in sequence: it provides flow to the secondary circuit when a primary circuit function has been completed reaching the pressure setting.
These valves allows the division of inlet flow into two parts (50/50) and they unify it in the reverse direction irrespective of any pressure differences and flow.
Valve used to adjust flow speed.
In the check valves flow is free in one direction and blocked in the reverse one.
Made up by 2 relief valves with crossed tank, this valve is used to block pressure to a certain setting in the 2 ports of an actuator/hydraulic motor. It's ideal ...
Valve that provides overload protection in a fast and accurate way: when it reaches pressure setting, the valve opens allowing pressure relief in order not to exceed this setting.
Valves used to control actuator's movement and block in one (single effect) or both (double effect) directions in order to enable the following functions:- the under ...
Valves used to block a cylinder in one (single) or both (double) directions. The flow is free in one direction and blocked in the reverse direction until pilot pressure is applied.
Via Dell `Artigianato 3/17
Telefon: +39 030 2629171
Fax: +39 030 2629788
Auf der Merkliste