HANNOVER MESSE 2020,
20 - 24 April
Our company produces de-tuned capacitor banks with thyristor switches for factories and facilities, which use lifts, elevators, arc furnaces, welding machines, etc.. This type of panel differs from the de-tuned capacitor bank panel because of the fact that the switching is done with thyristor switches and the reactive power controller is a rapid one with transistor outputs.
-The body and interior installation carriers assembled with perforated profile cap screws. Universal and serial layout potentiality with square hole system
-2mm sheet iron, RAL 7032 powder paint
-2mm sheet iron, galvanized after engraving the interior installation carriers
-Panels with one lid in front, side and back lids with perforated sheet iron for ventilation
-The copper bar is placed at the top of the panel, which is equipped with NH-fuse switch disconnector, thyristor switch, reactor and capacitor in descending order. Capacitors are placed at the bottom of the panel, which has the lowest temperature
-System design is made by a three phase capacitors and therefore, cabling is not complex
-All cabling is engineered with flexible NYAF cables and is conformable with fuse ampere value
-Energy could be extracted from the main bar without fenestration
Our company manufactures medium voltage capacitor banks to compensate the reactive power of medium voltage motors and transformers. They are pressure switch protected ...
We manufacture MV capacitor banks for the MV systems where high reactive power need is present.
Facilities and factories with a high proportion of variable speed motor drives and/or other harmonic generating loads may require a detuned capacitor system. This ...
During the switch of a acapacitor bank ,the switching transient current is very high.The current can even be very close to the short circuit current level.By mounting ...
Our company build de-tuned capacitor bank modules in order to increase the production of low voltage de-tuned capacitor banks. The capacitor bank module has a fuse, ...
Power Transmission and distribution systems are designed for operation with sinusoidal voltage and current waveforms at a constant frequency. However, when non-linear ...
The traditional method of reactive energy compensation is to directly connect the capacitor banks to the main network.
However, it is not suitable to connect the ...
When a motor is driven by a mechanical load in the case of cranes or lifts, it acts as a generator, which converts kinetic energy into electrical energy. If there ...
Line/load reactors help to keep your equipment to run longer by absorbing many of the disturbances especially the spikes coming from the electrical system which ...
Limiting fault currents becomes very important at protecting generator windings. For that reason we are manufacturing generator neutral grounding resistor panels ...
Because of the fact that the fault currents at star point grounded mains should be limited, transformers/generators are grounded over star point with neutral grounding ...
We manufacture one phase , three phase and dry type transformators for different applications.
Shunt Reactors are used in the systems where inductive load is needed, such as to eliminate the capacitive load of the cables and to prevent paying reactive energy ...