HANNOVER MESSE 2020,
20 - 24 April
ROTOR PROFILE: VMC has engineered its own rotor profile in order to reach maximum performance even in the most extreme conditions and guarantee efficiency and duration. This means a higher air-flow rate for less energy consumption.
ROTOR ADJUSTMENT: Threaded nuts are used to adjust rotors for very fast and reliable maintenance. BEARINGS: Radial and thrust bearings have been engineered for generous reserve. Only first-quality bearings are used. SHAFT SEAL: An excellent reliability of shaft seal, thanks to the use of first-rate quality materials leads to no oil leakages.
VERSIONS available: belt and gear-driven.
DIRECT DRIVEN: Air-ends can be supplied with the relative direct-driven kit (bell housing + spider couplings).
SPECIAL APPLICATION: Air-end are also available for Natural Gas applications.
VMC widens its product range and starts a new revolution in the world of compressed air. From now on, you can design your screw compressor using the Pack Smart technology ...
A thermostatic valve is installed among the separator tank, the cooler and air-end housing. It is run by a thermostatic unit available at different working temperatures ...
An idling device is usually installed on the air tank receiver of a piston compressor to control its working pressure. It includes a non-return valve and an adjusting ...
The VTDM Combination Block system includes a thermostatic valve, a minimum pressure valve, supports for spin-on separators, oil filters and relative nipples, as ...
The VDM Combination Block system includes a minimum pressure valve, supports for spin-on separators and relative nipples, as well as extra ports to monitor pressure ...
Much greater performance and reliability. VMC's new gear series has been conceived to guarantee high performance to air compressors. A wide range is available from 3 up to 100HP.
Assembled on the inlet port of an air-end housing, the intake valves of the RB & RBC series are Normally Closed. They include a butterfly operated by a servo-cylinder ...
Air-oil separation integrated system realized with a patented oil separator, implementing the mechanical pre-separation. Practiko 10UD is made up of a flanged cover ...
Assembled on the inlet port of an air-end housing, the intake valves of the RH & RHC Series are Normally Open (NO) and only with a vertical design. They include ...
Usually installed on the discharge port of the separator tank, minimum pressure valves are available in a threaded or flanged version. They include a poppet to maintain ...